16L Water Dispenser Instructions

16L Water Dispenser Setup & Maintenance Guide

Congratulations on choosing the Aimex 16L Water Purifier. To ensure you enjoy the cleanest, most refreshing alkaline water, it is essential to set up your system correctly. Follow this comprehensive guide for assembly, filter preparation, and long-term care.

1. Before You Begin: Filter Preparation

Properly "priming" your filters is the most important step to ensure high water quality and prevent slow flow.

  • 8-Stage Filter Cartridge: Submerge the filter in a clean bucket of water for at least 12 hours. Gently shake it while submerged to remove air bubbles. Once soaked, rinse it under a cold tap until the water runs clear.

  • Ceramic Dome Filter: Soak the ceramic dome in a separate bowl of water for 10–15 minutes. Use a soft sponge (no soap!) to gently wipe the surface.

2. Step-by-Step Assembly Instructions

  1. Base & Tap: Place the base on a flat surface. Attach the tap to the lower tank, ensuring the washers are tight on both the inside and outside to prevent leaks.

  2. Lower Tank: Place the lower tank onto the base.

  3. Middle Joiner: Place the joining ring on top of the lower tank. Screw the 8-stage filter into the bottom of the joiner/top tank assembly.

  4. Upper Tank: Place the upper tank into the joiner. Install the Ceramic Dome by securing it through the hole in the upper tank with the provided nut.

  5. Final Step: Place the lid on top and ensure all components are seated flush.

3. Initial Flushing Process

After assembly, fill the top tank. Let the water filter through to the bottom tank and then discard the first full 16L cycle. This removes any remaining fine carbon dust from the manufacturing process. Your second batch is ready to drink!

4. Maintenance & Troubleshooting

To keep your Aimex Water Dispenser performing at its best, follow these maintenance tips:

  • Slow Filtration? If the water flow slows down, remove the ceramic dome and gently scrub the surface with a clean abrasive pad or soft brush under running water.

  • Cleaning: Wash the tanks once a month with warm water and a small amount of natural vinegar. Avoid harsh chemicals. Recommended every month

  • Filter Replacement: For optimal health benefits and fluoride reduction:

    • 8-Stage Filter: Replace every 6 months or 5,000L.

    • Plastic Dome: Replace every 12 months.

5. Critical Tip: Placement & Algae Prevention

Keep your water dispenser away from direct sunlight. Because the Aimex filtration system is highly effective at removing chlorine and chemicals, the resulting "pure" water lacks the synthetic preservatives found in tap water. If exposed to direct sunlight or high heat, algae can begin to grow in the tank. For the best results.

  • Store your unit in a cool, shaded area of the kitchen or office.

  • Avoid window sills or countertops that receive afternoon sun.

  • If you notice a green tint, wash the tanks thoroughly with a natural vinegar solution and move the unit to a darker spot.

Frequently Asked Questions (FAQ)

How do I stop my water dispenser from leaking? Check that the tap washers are positioned correctly—one on the inside and one on the outside of the tank—and ensure the tap is tightened firmly.

Why does my water taste metallic or different? This usually happens if the filters weren't soaked long enough. Re-soak your 8-stage filter for 30 minutes and flush the system once more.